Are all Jeep Dana 30 the same?

Are all Jeep Dana 30 the same?

No, not all dana 30 pinions are the same length. The original 30 from my 2000 TJ had a pinion that was something like an inch shorter than the Cherokee axle I put in it.

What vehicles have a Dana 30 front axle?

Comanche, Cherokee, and Grand Cherokee Dana 30 The Comanche (MJ) and Cherokee (XJ) use a reverse cut Dana 30 and the Grand Cherokee (ZJ) uses a normal cut Dana 30. Like the YJ and the TJ, these axles use a 5 on 4.5″ wheel bolt pattern. All of these trucks use coil springs up front.

Is a Dana 30 strong?

Dude, the Dana 30 is THE BEST axle that was ever built by Dana. It’s stronger than a 44, 60, or Dana 70 from a 1/2 ton truck.

Can Dana 30 Handle 35 tires?

Yes. A Dana30 with 30-spline shafts will be fine for 35″ tires.

Can you run 35s on a Dana 35?

Registered. Had 35s on my stock dana 30/35 for about 8 months and wheeled it pretty hard and had no problems.

Can a Dana 30 handle a locker?

The stock Dana 30 and Dana 44 are still fine with 33’s and lockers so long as you’re not hammering them with heavy throttle and driving stupid.

Can you run 37s on a Dana 30?

If you took it out wheeling with 37s on the stock Dana 30, I have no doubt you’d probably break some axle shafts in short order. However, with alloy shafts and responsible driving (meaning not using heavy throttle every time you get in a sticky situation) you should be just fine.

What is a super Dana 30?

Here is what is “super” about the Super 30 kit: 30 Spline axles with a 30 spline ARB (vs. 27 spline axles for the stock 30). Superior Alloy Axles, inners and outers. Your choice of U-joints.

Can I fit 37 on a 4 inch lift Jeep?

The best size tire for a 4-inch lift on a Jeep JK is 37 inches. These tires will perform with excellence. Sizes smaller will work. A 38-inch tire can fit but might be a little tight.

How much of a lift do I need for 37 inch tires?

3.5″

Can you fit 37 inch tires on a 4 inch lift?

Some 37s will work with the rims used for 35s. Remember, 37s are usually much wider tires, and this will have an effect on the demands of the rims’ width and offset. So, the width of those current rims just may not cut it. Do your homework and determine if the wheels you’re currently running will work.

Will a 4 inch lift clear 35s?

You can go 35’s. It all depends on if you want to trim and what offset your running. Also you can always crank it up to run bigger tires but then you lose the comfy ride just like you did to fit 33’s on a leveled truck.

What is the best size tire for a 4 inch lift?

Either a 35” or a 37” size tire would give you the best balance of performance and ability for a 4-inch truck lift.

Can you fit 35 inch tires on a 4 inch lift?

4inch lift fit 35s You will need a six lift to fit 35s on your truck.

What size lift is needed for 35 inch tires?

Upgrading to 35-inch tires: If you plan on upgrading to a 35-inch tire, you will need a lift of at least 2.5 inches for proper clearance. At most you’ll need a 3.5 inch lift.

What size lift do I need for 35 inch tires Jeep TJ?

Highly recommend the 1.25″ body lift. Took me about an hour to put it on by myself.